The Hague Substructure can be assembled on location by two men in 1.5 hours with the use of a 50 ton crane and either a small picker or a loader with forks. The unit is installed typically at mid range of travel and becomes a work floor for changing BOP components and building the rest of the BOP stack. After installation of the substructure the BOP stack legs are extended, cylinders are stroked, appropriate load is taken off the BOP stack and the structure is pinned in place and hydraulic pressure is relieved from cylinders.

• 5.2 by 5.2 meter footprint
• Rigged up as integral part of BOP stack using adapters
• Adapters are available for all sizes up to 13- 5/8 10m
• Infinitely variable rig up height between 4.2 meters and 6.7meters
• Rated capacity 460,000 lbs, full documentation with certification
• The substructure is shipped in 5 pieces and all can be carried on one triple axle trailer without exceeding the deck width, avoiding the need for wide load signage or pilot vehicles
• Can be transported off highway on a single high boy trailer fully assembled